[driverloader] problems with broadcom card and driverloader 1.36
Mark Christopher Hodgkinson
markhod at SLAC.Stanford.EDU
Mon Nov 10 11:20:40 EST 2003
Hello,
I succesfully installed driverloader 1.36. I can even connect to a
wireless network. However I cannot view websites or ssh over this
connection. If I run dmesg I see:
eth1: New link status: Disconnected (0002)
eth1: at 00:09.0 (MAC address 00:90:4B:42:36:69) ready
eth1: New link status: Connected (0001)
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
eth0: Autonegotiation advertising 0x5e1 partner 0x00.
eth0: link down.
eth0: Autonegotiation advertising 0x5e1 partner 0x00.
eth0: link up.
eth0: Autonegotiation advertising 0x5e1 partner 0x21.
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
eth1: New link status: Disconnected (0002)
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
driverloader: ndisSetInformation: 802_11_DESIRED_RATES st=NOT_SUPPORTED
W=0 N=0
If I run /sbin/iwconfig I see:
eth1 Scan completed :
Cell 01 - Address: 00:40:96:47:49:E2
ESSID:"visitor"
Mode:Managed
Frequency:2.462GHz
Quality:1/1 Signal level:-67 dBm Noise level:-200
dBm
Encryption key:off
Bit Rate:1Mb/s
Bit Rate:2Mb/s
Bit Rate:5.5Mb/s
Bit Rate:11Mb/s
Cell 02 - Address: 00:40:96:54:B2:D4
ESSID:"visitor"
Mode:Managed
Frequency:2.437GHz
Quality:1/1 Signal level:-77 dBm Noise level:-200
dBm
Encryption key:off
Bit Rate:1Mb/s
Bit Rate:2Mb/s
Bit Rate:5.5Mb/s
Bit Rate:11Mb/s
So it seems I am connected, so why cant I use the network?
Thanks,
Mark.
More information about the driverloader
mailing list