[driverloader] More Info Connection problem with LinuxantDriverloader, Drake 9.2, Linuxant

[Linuxant support]

Hi,

did you by any chance use the same IP address on your ethernet card also, or
was it a different IP?

If you used the same IP, then you probably need to reset your access point
because the wrong MAC address would be cached for this IP address.

Also verify with the command "arp -na" if the MAC address of your AP is
associated with 192.168.0.1 after a ping.

Regards,

Jean-Simon Durand
Technical specialist / Linuxant
www.linuxant.com
support at linuxant.com


----- Original Message ----- 
From: "Jeremy Swanson" <jswanson at andersonranch.org>
To: <driverloader at lists.linuxant.com>
Sent: Thursday, January 08, 2004 10:01 PM
Subject: [driverloader] More Info Connection problem with
LinuxantDriverloader, Drake 9.2, Linuxant


Thanks so much!
Here's the info that has been asked for--
My gateway router/wireless ap is at address 192.168.0.1 The laptop wireless
card typically picks up 192.168.0.3 from the DHCP server on the AP/router.

ipaddr
1: lo <LOOPBACK,UP> MTU 16436 qdisc noqueue
   link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
   inet 127.0.0.1/8 brd 127.255.255.255 scope host lo
2: eth0 <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 100
   link/ether 00:0d:9d:43:c1:d0 brd ff:ff:ff:ff:ff:ff
3: eth1: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc phifo_fast qlen 100
   link/ether 00:90:4b:41:d9:93 brd ff:ff:ff:ff:ff:ff
   inet 192.168.0.3/24 brd 192.168.0.255 scope global eth1

iproute
192.168.0.0/24 dev eth1 proto kernel scope link src 192.168.0.3
127.0.0.0/8 dev lo scope link
default via 192.168.0.1 dev eth1

Kernel IP routing table
Destination  Gateway      Genmask        Flags Metric Ref Use Iface
192.168.0.0  0.0.0.0      255.255.255.0  U     0      0   0   eth1
127.0.0.0    0.0.0.0      255.0.0.0      U     0      0   0   lo
0.0.0.0      192.168.0.1  0.0.0.0        UG    0      0   0   eth1