[driverloader] it connects and disconnects every 5 minutes andtxpower

[Cristiano De Michele]

On Thu, 2004-02-05 at 18:43, Linuxant support (Jean-Simon) wrote:
> Hi,
> 
> usually, setting the "txpower" directly using 'iwconfig' is not supported.
> Please look in the "advanced settings" using the web configurator.
no there isn't such a setting 
> Also, you might find a setting that can affect the other behavior that you
> described (the reconnection at each 5 minutes).
no there isn't this setting either,
there is only the "CalibrationInterval" in
/etc/driverloader/config/<MAC_OF_MY_CARD>,
should I change this one?
> Regards,
best regards
Cristiano


> ----- Original Message ----- 
> From: "Cristiano De Michele" <demichel at na.infn.it>
> To: "linuxant-driverloader" <driverloader at lists.linuxant.com>
> Sent: Tuesday, February 03, 2004 5:59 AM
> Subject: [driverloader] it connects and disconnects every 5 minutes
> andtxpower
> 
> 
> UP!
> 
> Hi,
> I have a USR805410 card and
> driverloader works fine
> (to the point that I purchased a license
> from your site) except that
> every 300 seconds it disconnets and reconnets right after,
> in fact in /var/log/syslog I have:
> eth1: New link status: Disconnected (0002)
> eth1: New link status: Connected (0001)
> eth1: New link status: Disconnected (0002)
> eth1: New link status: Connected (0001)
> eth1: New link status: Disconnected (0002)
> eth1: New link status: Connected (0001)
> eth1: New link status: Disconnected (0002)
> eth1: New link status: Connected (0001)
> piro:~# tail /var/log/syslog
> .
> .
> .
> Jan 29 16:27:02 piro kernel: eth1: New link status: Disconnected (0002)
> Jan 29 16:27:02 piro kernel: eth1: New link status: Connected (0001)
> Jan 29 16:32:02 piro kernel: eth1: New link status: Disconnected (0002)
> Jan 29 16:32:02 piro kernel: eth1: New link status: Connected (0001)
> Jan 29 16:37:02 piro kernel: eth1: New link status: Disconnected (0002)
> Jan 29 16:37:02 piro kernel: eth1: New link status: Connected (0001)
> 
> I noticed that 300 seconds is the 'Calibration Time'
> hence I ask: is it ok that during calibration it disconnects
> and reconnects every time?
> Another issue is that txpower seems to be not supported
> for my USR805410, will it be or can't the TI chipset handle
> it?
> 
> thanks
> Cristiano
> 
> _______________________________________________
> driverloader mailing list
> driverloader at lists.linuxant.com
> https://www.linuxant.com/mailman/listinfo/driverloader
-- 
  Cristiano De Michele,
  Department of Physics,
  University "Federico II" of Naples