Hi,
according to the output of the 'iwconfig' command you have sent us, you
are not connected to an access point since we do not see the MAC address
of your wireless card in the output of the previous command, even if you
set the ESSID parameter.
Could you please send at support at linuxant.com the output of 'dumpdiag'?
Type the following in a root shell:
---
dldrconfig --dumpdiag
---
Just send us the generated file located in /tmp
('driverloaderdiag.txt'). It'll help us solve the problem.
Regards,
Jonathan
Technical specialist / Linuxant
www.linuxant.com
support at linuxant.com
Nick Davies wrote:
> First post, apologies to all if I get the etiquette wrong.
>
> A relative n00b to the world of linux, I am running SuSE 9.1 and
> attempting to climb the himalayas. Sorry, I meant get my wireless
> adaptor to connect to the network. Two weeks in the ndiswrapper
> foothills, (impossible to set essid, lots of posts everywhere, no
> solutions), I find myself staring at driverloader. It loads the driver,
> it recognises my adaptor, it looks configurable but it remains
> disconnected. Please help. I'm not sure I can take any more of this...
>
> dmesg, ifconfig and iwconfig as follows.
> dmesg
> wlan0: WPA, AES, TKIP, WEP128, WEP64 supported
> wlan0: Realtek RTL8180 Wireless LAN (Mini-)PCI NIC at 0000:01:06.0 (MAC
> address 00:50:FC:BD:FB:62) ready
> NET: Registered protocol family 17
> wlan0: New link status: Disconnected (0002)
> --- stuff cut out here ---
> wlan0: no IPv6 routers present
>
> ifconfig
> wlan0 Link encap:Ethernet HWaddr 00:50:FC:BD:FB:62
> inet6 addr: fe80::250:fcff:febd:fb62/64 Scope:Link
> UP BROADCAST NOTRAILERS MULTICAST MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:22 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
>
> iwconfig
> IEEE 802.11-DS ESSID:"101" Nickname:"HOME"
> Mode:Managed Bit Rate=11Mb/s Tx-Power=20 dBm
> RTS thr:off Fragment thr:off
> Encryption key:off
> Power Management:off
> Link Quality:0 Signal level:0 Noise level:0
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>
> _______________________________________________
> driverloader mailing list
> driverloader at lists.linuxant.com
> https://www.linuxant.com/mailman/listinfo/driverloader