[driverloader] setup on FC3/KDE

[Linuxant support (Jonathan)]

Hi,

we recommend that you use the network configuration tool provided in the 
Linux distribution. Under Fedora Core 3, you can launch this graphical 
tool with the 'neat' command in a shell.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
support at linuxant.com


Neal Becker wrote:
> Hi, I'm testing on my new compaq r3000z, x86_64/FC3.  Install was OK I think:
> eth1: New link status: Disconnected (0002)
> eth1: WPA, AES, TKIP, WEP128, WEP64 supported
> eth1: at 0000:02:02.0 (MAC address 00:90:4B:B7:1E:D2) ready
> 
> Only question, what is a good user interface to configure my wireless under 
> KDE?
> _______________________________________________
> driverloader mailing list
> driverloader at lists.linuxant.com
> https://www.linuxant.com/mailman/listinfo/driverloader