[driverloader] (no subject)

[raoul.linux at chello.nl]

some more info :

when I try to do an ifup eth1 I get the following error :
ifup eth1
RTNETLINK answers: Invalid argument

Hope someone can help. 

> 
> van: <raoul.linux at chello.nl>
> datum: 2006/02/13 ma PM 10:01:02 MET
> aan: <driverloader at lists.linuxant.com>
> onderwerp: [driverloader] (no subject)
> 
> All,
> 
> I have a question/problem I am no newby but no expert either so bare with me :
> 
> I have a Linnksys WPG54C card with a TI acx111 chipset.
> 
> I used the linuxant driver to see if I could get this working. 
> 
> Well, I came far but not far enough and was hoping someone could shet a light on my problem:
> 
> During the boot process I am getting an error about the    /var/run/cardmgr.pid  : Read only filesystem
> 
> Later in the bootprocess there is also a message displayed that another cardmgr is running.
> 
> My wlan card is active as eth1, all looks good, I am connected to my AP, but when I tried to ping my default route (is my AP), I get error messages.
> Also I don't get the IP address I configured but a 169.254.0.0 which I believe is a default in case no network can be found
> 
> When I tried to activate my wlan card (via the menu) I get an error saying :set mode : 8BD06 not supported. 
> 
> I used all the default values, and looking in the startup scripts and can't find anything.
> 
> Have someone seen this before, does anyone know how to solve. I don't mind paying if I can get this thing to work.
> 
> General info
> 
> Fedora Core 4
> Kernel : 2.6.15-1.1831_FC4.stk16
> 
> iwconfig info :eth1  (blanked out private date)
>          IEEE 802.11g  ESSID:"xxxxx"  Nickname:"xxxxxxx"
>           Mode:Managed  Frequency:2.412 GHz  Access Point: xx:xx:xx:xx:xx:xx
>           Bit Rate=54 Mb/s   Tx-Power:10 dBm
>           RTS thr:off   Fragment thr:off
>           Encryption key:off
>           Power Management:off
>           Link Quality=72/94  Signal level=-43 dBm  Noise level=-154 dBm
>           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> 
> In the config tool, all is ok,
> 
> Kind regards,
> 
> Raoul 
> 
> 
> 
> _______________________________________________
> driverloader mailing list
> driverloader at lists.linuxant.com
> https://www.linuxant.com/mailman/listinfo/driverloader
>