[hcflinux] <TERMINATION CAUSE=Carrier lost>

[Franki]

Goodmorning people..

I have the new driver.. and its installed and working.. and I have looked at
the bugs section of the site and done the stuff to get the error messages
from my disconnection problem..

Below is what I got...

My ISP has a strict rule, they can disconnect me, but will always send me an
email via deamon with ten minutes notice..
so the disconnection is not from them.. (and it has done this twice now in
an hour.) the phone line is clean.. and on windows I get very fast
connections, (5-7k downloads) as I do on linux when it stays connected.
It would seem that the timeouts are too small for some connections?
resulting in the modem thinking the connection has been dropped when it
hasn't??? is that a possibility?


rgds

Frank

The full details:


<#UG VERSION=1>
<UNIMODEM VERSION=10>
<CALL SETUP RESULT=Detected Data Answer Tone>
<MULTIMEDIA MODE=Data Only>
<DTE-DCE MODE=Async data>
<V.8 CM octet string="">
<V.8 JM octet string="">
<RX SIG POWER DB=39, TX SIG POWER DB=15, S/N RATIO DB=24>
<NORMALIZED MEAN SQUARED ERROR=0>
<NEAR ECHO LOSS=0>
<FAR ECHO LOSS=0>
<FAR ECHO DELAY=0>
<ROUND TRIP DELAY=0>
<V.34 INFO bit map =0>
<TX MOD=V.90, TX SYMBOL RATE=3200, TX CARRIER FREQ=1829>
<RX MOD=V.90, RX SYMBOL RATE=3200, RX CARRIER FREQ=0>
<TX FIRST DATA RATE=28800, RX FIRST DATA RATE=42667>
<CARRIER LOSS=1, RATE RENEG=3>
<RETRAINS REQ=0, RETRAINS DET=1>
<TX FINAL RATE=24000, RX FINAL RATE=36000>
<PROTOCOL NEGOTIATION=LAPM>
<EC FRAME SIZE=100>
<EC LINK TIMEOUTS=0>
<EC LINK NAKS=0>
<COMPRESSION NEGOTIATION=V42BIS>
<COMPRESSION DICTIONARY SIZE=800>
<TX FLOW CONTROL=2>
<RX FLOW CONTROL=2>
<TX CHARS SENT FROM DTE=15906>
<RX CHARS SENT TO DTE=99152>
<TX CHARS LOST=0>
<RX CHARS LOST=0>
<TX FRAME COUNT=3D6>
<RX FRAME COUNT=C47>
<TX FRAME ERROR COUNT=A5>
<RX FRAME ERROR COUNT=9>
<TERMINATION CAUSE=Carrier lost>
<LSD Vdd=0, Power Bits=0>
<V8BIS FLEX VERSION=0, V8BIS DSP VERSION=46>
<RATE RENEG REQ=1, RATE RENEG DET=2>
<HIGH PASS FILTER ENABLED=0>
<ROBBED BIT PATTERN=0>
<DIGITAL PAD DETECTED=0, DIGITAL LOSS ESTIMATE=2000>
<Cnt1=0, Det1=0, Res1=0>
<EQM=7FFF, TRAINING EQM SUM=11F52>
<DIB ERROR COUNTERS=0, 0, 0, 0, 0, 0, 0, 0>
<RETRAIN/HDLC RESET=0>