<html>
<head>
</head>
<body>
Jean-Simon Durand wrote:<br>
<blockquote type="cite" cite="mid:0b8301c31a50$9a16d7c0$1300a8c0@peon">
<pre wrap="">Hi,<br><br>I would like to point out that you should not use setserial to configure a<br>software modem.<br><br>This is an excerp from the HCF drivers FAQ:<br><br>---<br>Changing serial port parameters with "setserial" on ttySHCF0 or /dev/modem<br>doesn't work.<br><br>Since this modem driver provides a virtual serial interface, which is not<br>directly connected to a physical UART like a normal serial port, it is not<br>possible and would not make sense to configure it with "setserial".<br>Therefore you shouldn't use this command on the ports associated with this<br>driver. The irq and other parameters shown by "setserial" are bogus values<br>which have no meaning.<br>---<br></pre>
</blockquote>
Ooops, o.k. But I know it does work on some types of modem cards. It is
a virtual serial port. I wonder is this related to the fact that only one
hcf modem can be installed at time? Still one should find information about
the modem on /proc/pci or in a distribution's hardware information utilities.
It should show up there or there's something wrong. <br>
<blockquote type="cite" cite="mid:0b8301c31a50$9a16d7c0$1300a8c0@peon">
<pre wrap=""><br>Regards,<br><br>Jean-Simon<br><br><br>----- Original Message -----<br>From: "George Bell" <a class="moz-txt-link-rfc2396E" href="mailto:gbell5@cox.net"><gbell5@cox.net></a><br>To: "hcflinux" <a class="moz-txt-link-rfc2396E" href="mailto:hcflinux@lists.mbsi.ca"><hcflinux@lists.mbsi.ca></a><br>Sent: Wednesday, May 14, 2003 2:30 PM<br>Subject: Re: [hcflinux] suggestions<br><br><br>patrick reen wrote:<br><br></pre>
<blockquote type="cite">
<pre wrap="">George - entered setserial - got 'setserial -g<br>/dev/ttySHCF0/dev/ttySHCF0, UART: undefined, Port: 0x0001, IRQ:<br>0<br></pre>
</blockquote>
<pre wrap=""><!----><br>Ooops! That's bad. No IRQ or port no. so not even worth going on with<br>minicom or internet connection wizard. O.K. so do the following:<br>[...]<br><br><br></pre>
</blockquote>
<br>
<br>
</body>
</html>