[hsflinux] NO DIALTONE HSF

[Robert SHEN]

The problem is without ATX3, I got a NO DIALTONE message, therefore I tried
to use the ATX3 as suggested in the FAQ, but cannot work neither.

----- Original Message -----
From: "sapo" <sergiomb at net.sapo.pt>
To: "Robert SHEN" <shen at hkug.net>
Sent: Monday, May 06, 2002 5:34 AM
Subject: RE: [hsflinux] NO DIALTONE HSF


> If you use ATX3 it is impossible get a NO DIALTONE because you dont wait
for
> dial tone
>
> > -----Mensagem original-----
> > De: hsflinux-admin at lists.mbsi.ca [mailto:hsflinux-admin at lists.mbsi.ca]Em
> > nome de Robert SHEN
> > Enviada: sexta-feira, 3 de Maio de 2002 1:05
> > Para: hsflinux at lists.mbsi.ca
> > Assunto: [hsflinux] NO DIALTONE HSF
> >
> >
> > I have installed the latest hsflinux drivers 4.06.06.02 from
> > www.msbi.ca/cnxtlindrv on mu linux 7.2. The installation process was
> > successfull, but when I tried to dial, the response is NO DIALTONE, I
> > attempted to use the command ATX3 in vain.
> >
> > Modem config using a listmodem.sh downloaded from the internet
> > Vendor Id : 127A
> > Device Id : 1025
> >
> > it is a Conexant HSF modem
> >
> > but when I typed lspci, it shows a Rockwell International HCF modem
> >
> > why? any suggestion?
> >
> > _______________________________________________
> > hsflinux mailing list
> > hsflinux at lists.mbsi.ca
> > http://www.mbsi.ca/mailman/listinfo/hsflinux
> >